cs-2.90.29 980515 (egcs-1.0.3 release)) #2 Thu May 13 12:28:17 PDT 1999
Starting kswapd v 1.4.2.2 
Serial driver version 4.13p1 with no serial options enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
Cyclades driver 2.1.1.11 1998/12/30 18:58:47
        built May 13 1999 12:30:10
Cyclom-Y/PCI #1: 0xc8000-0xcbfff, IRQ7, 32 channels starting from port 0.
ide: Intel 82371 (single FIFO) DMA Bus Mastering IDE 
    Controller on PCI bus 0 function 33
ide: timings == a307a307
    ide0: BM-DMA at 0xd800-0xd807
    ide1: BM-DMA at 0xd808-0xd80f
hda: QUANTUM FIREBALL ST3.2A, 3079MB w/81kB Cache, CHS=782/128/63, UDMA
hdc: WDC AC28400R, 8063MB w/512kB Cache, CHS=16383/16/63, UDMA
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
(scsi0) <Adaptec AHA-394X Ultra SCSI host adapter> found at PCI 4/0
(scsi0) Wide Channel A, SCSI ID=7, 16/255 SCBs
(scsi0) Warning - detected auto-termination
(scsi0) Please verify driver detected settings are correct.
(scsi0) If not, then please properly set the device termination
(scsi0) in the Adaptec SCSI BIOS by hitting CTRL-A when prompted
(scsi0) during machine bootup.
(scsi0) Cables present (Int-50 NO, Int-68 YES, Ext-68 NO)
(scsi0) Downloading sequencer code... 419 instructions downloaded
(scsi1) <Adaptec AHA-394X Ultra SCSI host adapter> found at PCI 5/0
(scsi1) Wide Channel B, SCSI ID=7, 16/255 SCBs
(scsi1) Warning - detected auto-termination
(scsi1) Please verify driver detected settings are correct.
(scsi1) If not, then please properly set the device termination
(scsi1) in the Adaptec SCSI BIOS by hitting CTRL-A when prompted
(scsi1) during machine bootup.
(scsi1) Cables present (Int-50 NO, Int-68 NO, Ext-68 NO)
(scsi1) Downloading sequencer code... 419 instructions downloaded
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.13/3.2.4
       <Adaptec AHA-394X Ultra SCSI host adapter>
scsi1 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.13/3.2.4
       <Adaptec AHA-394X Ultra SCSI host adapter>
scsi : 2 hosts.
  Vendor: SEAGATE   Model: ST19171W          Rev: 0024
  Type:   Direct-Access                      ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
  Vendor: SEAGATE   Model: ST34572W          Rev: 0876
  Type:   Direct-Access                      ANSI SCSI revision: 02
Detected scsi disk sdb at scsi0, channel 0, id 8, lun 0
scsi : detected 2 SCSI disks total.
(scsi0:0:0:0) Synchronous at 40.0 Mbyte/sec, offset 8.
SCSI device sda: hdwr sector= 512 bytes. Sectors= 17783112 [8683 MB] [8.7 GB]
(scsi0:0:8:0) Synchronous at 40.0 Mbyte/sec, offset 8.
SCSI device sdb: hdwr sector= 512 bytes. Sectors= 8888924 [4340 MB] [4.3 GB]
PPP: version 2.2.0 (dynamic channel allocation)
TCP compression code copyright 1989 Regents of the University of California
PPP Dynamic channel allocation code copyright 1995 Caldera, Inc.
PPP line discipline registered.
3c59x.c:v0.99H 11/17/98 Donald Becker http://cesdis.gsfc.nasa.gov/linux/drivers/vortex.html
eth0: 3Com 3c905B Cyclone 100baseTx at 0xd000,  00:10:4b:96:3f:5f, IRQ 12
  8K byte-wide RAM 5:3 Rx:Tx split, autoselect/Autonegotiate interface.
  MII transceiver found at address 24, status 786d.
  MII transceiver found at address 0, status 786d.
  Enabling bus-master transmits and whole-frame receives.
Partition check:
 sda: sda1 sda2 sda3
 sdb: sdb1 sdb2
 hda: hda1 hda2 hda3
 hdc: hdc1 hdc2
VFS: Mounted root (ext2 filesystem) readonly.
Adding Swap: 130748k swap-space (priority -1)
Adding Swap: 130748k swap-space (priority -2)
Unable to find swap-space signature
SLIP: version 0.8.4-NET3.019-NEWTTY-MODULAR (dynamic channels, max=256).
registered device ppp0
registered device ppp1
registered device ppp2
registered device ppp3
registered device ppp4
registered device ppp5