------------------------------ Date: Tue, 20 May 1997 10:22:27 -0400 (EDT) From: Sheppard1 aol.com Subject: Brazing Bruce, this is in response to your earlier question concerning brazing. First you asked if you should use rosin or acid core, you should use an acid core solder or use a separate brush on acid flux. As for brazing, I would not recomend a propane torch with regular brazing rod. You probably could get by using that type of torch with a silver brazing alloy (45%silver) and silver brazing flux. This would be as strong as brazing rod and would melt at about 400 degrees lower temp. (When brazing, make sure that you are not unsoldering anything near by) Cracks in your radiatior might be resulting from lack of suspension between body and radiator. You might install rubber grommets between radiator and body. Hope this is helpful, Andrew Sheppard 89 GW ------------------------------ Date: Tue, 20 May 1997 10:46:33 -0400 (EDT) From: Sheppard1 aol.com Subject: Arc welding/mig welding This is in respons to a question regarding the use of a arc welder on body work. Better to use a mig welder but if you must use a arc welder, find a supply of 1/16" electrodes and use a skip weld technique, don't try to weld a continuous seam or you will probably burn through the sheet metal. Hope this is helpful, Andrew Sheppard GW89 (home today recuping from a pinched nerve after taking some guy's welding tank out of his trunk, older age is catching up with me :-( Just can't throw those things over my shoulder like I usta!:-) ------------------------------
Select pages from WAGONEERS.COM: Buy this FSJ decal... ...use PayPal to pay for it! |
AMSOIL synthetic lubricants and filters (please use customer #283461) Shop AMAZON.com from wagoneers.com!
|